SECTION 15210
HIGH-DENSITY POLYETHYLENE (HDPE) PIPE, FITTINGS, AND APPURTENANCES
PART 1 - GENERAL
1.1 SCOPE OF WORK
A. Furnish and install HDPE pipe and fittings for the landfill gas collection and
control system (GCCS), condensate main, and the compressed air supply.
B. Pressure test solid HDPE pipe.
1.2 DELIVERY, STORAGE, AND HANDLING
A. The pipe and fitting manufacturer shall package products for shipment in a
manner suitable for safe transport by commercial carrier. When delivered,
CONTRACTOR shall inspect the shipment and report any damage to the pipe and
fittings manufacturer. Pipe and fittings shall be handled, installed, and tested in
accordance with the Manufacturer’s recommendations, and the requirements of
this Section.
B. Pipe Storage:
1. Store or stack pipe to prevent damage from marring, crushing or puncture.
Limit maximum stacking height to 6 ft or the Manufacturer’s recommended
maximum height, whichever is less.
2. Store in accordance with the Manufacturer’s recommendations.
C. Pipe Handling:
1. Protect pipe from excessive heat or harmful chemicals.
2. Handle pipe and use equipment needed to avoid gouging of the pipe surfaces.
1.3 SUBMITTALS
A. CONTRACTOR shall submit to ENGINEER a Certificate of Conformance with the
Specifications.
B. CONTRACTOR shall submit documentation demonstrating that the pipe-welding
technicians are certified by the pipe manufacturer to weld HDPE pipe.
PART 2 - PRODUCTS
2.1 PHYSICAL PROPERTIES
A. Materials used to manufacture the HDPE pipe and fittings shall meet the following
physical property requirements:
SANBORN HEAD
