ENGINEERING DESIGN PHASE CONTRACT Page 2 of 5
For Professional Services for Treatment Works
|. SERVICES TO BE PERFORMED BY THE ENGINEER
A.
Upon execution of this AGREEMENT, the ENGINEER agrees to proceed with all engineering, surveying, drafting,
calculations, borings, and other work as required and necessary to develop and produce final plans, specifications,
and associated contract documents involved in the construction of treatment works for: Pump Station Upgrades -
Phase Il. Scope of Work, attached as Exhibit A and incorporated by reference as if fully set forth herein
1. Plans, Specifications, and Contract Documents
a. The preparation of detailed plans, specifications, and contract documents in accordance with the rules and
regulations of the New Hampshire Department of Environmental Services, Water Division, hereinafter called
the DIVISION, ready for the receipt of bids and the award of construction contracts for said construction; the
work shall also include the preparation of estimates of the cost of construction based on the contract
documents. Prepare-apes SHOR AA SH BO AoA OCtHHe eG -GOCctH Fer Oo CGF ttO-—coHFtG-8
Il. THE OWNER'S RESPONSIBILITIES
A.
Assist the ENGINEER by placing at his disposal all available information pertinent to the PROJECT, including previous
reports and other data relative to the reports.
Make provisions for the ENGINEER to enter upon public and private lands, municipal facilities and industrial
establishments as required to perform work under this AGREEMENT.
The OWNER also agrees to comply with DIVISION and Federal requirements (where applicable) and further agrees to
acquire with the assistance of the ENGINEER all the necessary easements, options or outright purchases of land for
the locations of said treatment works as shown on the contract plans. The provisions of this section shall be satisfied
prior to submission of documents referred to in III (A) below. It is also understood that no approvals of reports or
plans and specifications or other associated documents will be made by the DIVISION without fulfillment of this
requirement.
Wl. TIME OF COMPLETION
A.
The ENGINEER agrees that he will submit to the DIVISION for approval after modification or revision as
recommended by the DIVISION and agreed to by the ENGINEER, the completed final plans, specifications, contract,
and associated documents in compliance with the current issue of the DIVISION's standards of design within
consecutive calendar days following the execution of this AGREEMENT, and deliver same to the OWNER within
calendar days following the date of final approval by the DIVISION.
Rev.2020-09
