Nose Plows for 6 Wheel Truck
A. Asteel 11’ power angle trip edge plow with 4” mold
board, no tess than 40” high, punched to AASHO standards
12” on center with caster wheels shall be standard.
B. Plow shall be complete with a carbide cutting edge and
cover plate
_C. Trip edges shall be punched to accept a 132” standard hi-
way punch cutting edge
DB. The moldboard shail have 2 curb shoes (one each end of
| cutting edge), each curb shoe shall not be less. than 1-3/8”
thick,
E. 2 Caster wheels per plow shall be supplied.
F. The drive frame and reversing mechanism shall consist of
an “A” frame, a truss frame, and 2 single acting 3-1/2”
hydraulic cylinders with a 16” stroke.
3" Diameter
G. Moldboard and truss frame shall pivot about the “A”
frame on a removable lubricated pin not less than 3” in
diameter and-up-to-37-degrees-to either side of chassis
centerline.
H. The “A” frame shall be fitted with a 3 point lift chain
arraignment, this shall accommodate plow reversing
operations.
iFB1005-092719 6 Whee! Dump Truck Up-Fits
Page | 5
