Hinges are required to swing 180 degrees. Furnish hinges of sufficient throw
to clear the trim. For doors 60 inches or less in height, furnish two hinges and
furnish one additional hinge for each 30 inches of height or fraction thereof.
Where not supplied by the door manufacturer, furnish silencers for door
frames at the rate of three for each single door except weatherstripped doors
and doors with light or sound seals.
2.2. ACCEPTABLE MANUFACTURERS
A. Hinges shall be the product of the Stanley Security Solutions, McKinney
Products Company, or approved equal.
B. Locks shall be the product of Schlage, Stanley Security Solutions, or approved
equal.
C. Door closers shall be the product of LCN closers or approved equal. Sizes to
be determined by manufacturer’s recommendations for door size and
location.
D. Kickplates shall be as manufactured by Schlage, Baldwin Hardware, or
approved equal. All kick and armor plates shall be furnished with Phillips
undercut countersunk screws. Truss head screws are not acceptable.
E. Thresholds by Pemko or approved equal as indicated in Schedule.
F. Weatherstrip shall be as supplied by Pemko or approved equal.
2.3. KEYING
A. Supplier to meet with OWNER to determine keying requirements and obtain
final instructions.
B. Supply two keys for each lock.
C. Supply master keys in quantities as required by OWNER.
PART 3 - EXECUTION
3.1. INSPECTION
A.
B.
Verify that doors and frames are ready to receive work and dimensions are
as indicated on shop drawings.
Commencement of installation means acceptance of existing conditions.
File No. 3066.09 Door Hardware 08712- 4 of 5 December 2017
