8. In areas where a threshold is provided the clearance between the bottom
of the door and the threshold shall not exceed 34-inch. Where a threshold
is not provided, the clearance at the bottom of the door shall be a
maximum of %4-inch.
3.2 ADJUST AND CLEAN
A. Final Adjustments
1, Check and readjust operating finish hardware items in hollow metal work
just prior to final inspection.
2. Leave work in complete and proper operating condition.
3. Remove defective work and replace with work complying with the
specified requirements.
B. Immediately after erection, sand smooth all rusted and damaged areas of
prime coat, and apply touch-up of compatible air-drying primer.
[END OF SECTION]
S:\CONDATA\3200s\3265.00\Source Files\Technical Specifications\ Division 8 Specifications\08100 Metal Doors and Frames.docx
File No. 3066.09 Metal Doors and Frames 08100- 4 of 4 December 2017
