C.
D.
Provide anchors as recommended by the manufacturer.
Door Silencers - Except on weather stripped frames, drill stops to receive
three silencers on strike jambs.
2.3. FINISH HARDWARE
A.
Secure templates from the finish hardware supplier, and accurately install, or
make provision for, all finish hardware at the factory.
Prepare hollow metal units to receive mortised and concealed finish hardware,
including cutouts, reinforcing, drilling, and tapping in accordance with final
Finish Hardware Schedule and templates provided by hardware supplier.
Comply with applicable requirements of ANSI Al15 “Specifications for Door
and Frame Preparation of Hardware.” Locate finish hardware as shown on
final shop drawings.
PART 3 - EXECUTION
3.1 INSTALLATION
A.
Install doors in accordance with the shop drawings and the manufacturer's
installation instructions.
Install fire rated doors and frames in accordance with NFPA 80.
Placing Frames
1. Where practicable, place frames prior to construction of enclosing walls
and ceilings.
2. Set frames accurately into position, plumbed, aligned, and braced securely
until permanent anchors are set.
3. After wall construction is completed, remove temporary braces and
spreaders, leaving surfaces smooth and undamaged.
4. At in-place construction, set frames and secure to adjacent construction
with suitable anchorage devices.
5. All masonry openings at door bucks and frames in all exterior walls shall
be thoroughly caulked.
6. Door frames shall be adequately anchored, shall be installed plumb and
true and shall be perfectly adjusted to operate smoothly.
7. Doors and all their components and accessories shall be hung with all
hardware in perfect working order and alignment. Clearances between
door edges and bucks shall be the same around the perimeter and the
clearance shall not be less than %, -inch.
File No. 3066.09 Metal Doors and Frames 08100- 3 of 4 December 2017
