SECTION 06210
WOOD FRAMING AND INSULATION
PART 1 - GENERAL
1.1
1.2
1.3
1.4
SCOPE
A.
Section includes:
1. Wood products used for the sump riser building and panel boards.
2. Fasteners.
3. Ceiling insulation.
SUBMITTALS
A.
CONTRACTOR shall submit to the ENGINEER shop drawings for the proposed
Sump Riser Building stamped by a Professional Engineering licensed to practice
structural engineering in the State of New Hampshire that depict the foundation,
block masonry, reinforcement, wood framing, insulation, and other elements
required for a complete construction.
CONTRACTOR shall submit to the ENGINEER information for proposed
appurtenances, including but not limited to, leveling slate and steel shims,
expansion bolts, threaded studs, non-shrink cement mortar, plate washers and
nuts, and pressure treated members for sills.
DELIVERY, STORAGE AND HANDLING
A.
Deliver lumber, plywood, trim, and millwork to the job site in an undamaged
condition.
Stack materials to ensure ventilation and drainage. Protect against dampness
before and after delivery.
Store materials under cover in a well-ventilated enclosure and protect against
extreme changes in temperature and humidity. Do not store products in the
sump riser building.
PERMITS
A.
CONTRACTOR is responsible for retaining a structural engineer to design the
sump riser building in accordance with applicable building regulations.
CONTRACTOR shall obtain all local building and other permits required prior to
construction implementation.
File No. 3066.09 Wood Framing and Insulation 06210 - 1 of 6 December 2017
