coat. Care is to be taken on vertical and overhead surfaces to avoid sags or
runs. If this occurs, it must be sanded out and the area re-coated. If coating
of horizontal surfaces that will receive traffic is specified, a slip-resistant
aggregate, Sikagard 62 Granules, shall be incorporated into the mixed epoxy
resin coating at % lb/gallon.
When applying the coating, if possible never stop the application until the
entire surface has been coated. If possible always discontinue at an edge,
corner, or joint. Never let a previously coated film dry. Always coat into wet
film. Always apply the coating at a 45° angle to an edge, corner, or joint.
Adhere to all limitations and cautions for the epoxy resin as stated in the
manufacturers printed literature.
3.3. CLEANING
A. The uncured epoxy resin coating can be cleaned from tools with an approved
solvent. The cured epoxy resin coating can only be removed mechanically.
B. Leave finished work and work area in a neat, clean condition without evidence
of spillovers onto adjacent areas.
[END OF SECTION 03310]
P:\3000s\3066.09\Source Files\Type II App\Specifications\ Division 3 Specifications\03310 Concrete Coatings.docx
File No. 3066.09
Concrete Coatings 03310 - 3 of 3 December 2017
