Otterbine Barebo Inc.
C. Mounting the Stabilizers (Comet Spray Pattern Only)
1. Mount each of the four stabilizer plates to the top side of a bracket using a hex bolt, a fender washer, and a nylon
locknut as shown below.
2. Mount each of the four stabilizer plate assemblies from Step C1 to the top side of an outer hole in the float using an
eyebolt, a fender washer, and a nylon locknut as shown. Do not over tighten. Damage may occur to the float.
parts tist
ITEM) DESCRIPTION | PART NUMBER | QTY |
Comet Stabilizer Plates Kit
1 Stabilizer Bracket 4
2 Stabilizer Plate oe AL!
3 5/16-18x1-3/8" S/S Eyebolt _ | 4
4 5/16-18x3/4" S/SHexBolt =—-s«s§—s«:106-302 4!
5 5/16-18S/SNylonLockNut | = GP1208 | 8
6 5/16" Fender Washer 28-0008 =| 8
D. Screen Installation
Debris Screens help to prevent clogging of the aerator and
are available for all Otterbine aerators.
1. Place the unit upside down on blocks so the pump chamber
does not get damaged.
2. Pull screen over motor unit until it reaches the lip on the
float.
3. Make sure the cable/s are running through the bushing in
the screen.
4. Fasten the screen to the lip on the float with the washers
and screws provided so they are evenly spaced around the
diameter.
Parts List
ITEM DESCRIPTION , a PART NUMBER QTY |
1/4" Screen Kit / 12-0075 18
1/2" Screen Kit 12-0076 Aj
1 C3 Screen ; 1 |
1/4" 15-0022 !
1/2" 15-0023 i
2 5/S Sheet Metal Screw 6P2803B a)
3. 1" Fender Washer 800-011 9
www.otterbine.com
8 75-0073 Rev 08 60Hz Concept 3 1-800-AER8TER
