Otterbine Barebo Inc.
UNIT ASSEMBLY
READ THE INSTRUCTIONS: Improper assembly may result in damage to the unit.
NOTES:
*Genesis Pump Chamber; The Float MUST be mounted before the Genesis Throat Assembly (Shown on page 20).
(The unit will be received with the pumping chamber already mounted)
*5HP "Open Throat” Units (Sunburst, Gemini, Saturn); If applicable, the Supplemental Float must be mounted to
the Main Float before installing on Unit (See Below).
A. Supplemental Float Assembly
*If the Supplemental Float is already mounted to the Main Float, continue with main float assembly below.
1. Place Main Float top face down.
2. Place the Supplemental Float on the Main Float as shown in the photo below.
3. Ty-Rap the floats together in four places (1 in each pocket).
4. Continue mounting Main Float.
B. Main Float Assembly
1. Stand the unit upright and place the float onto it so the holes in the float line up with the holes in the mounting brackets.
2. Place a fender washer onto a hex bolt and insert into one of the four holes in the float making sure it also goes through
the hole in the steel mounting bracket on the unit. Repeat this for the three remaining holes.
3. Place a flat washer and a nylon locknut onto each of the four hex bolts. Tighten each nylon locknut.
CAUTION: Do not over tighten lock nuts, damage may occur to the float and/or pump chamber.
Fasten supplemental Float w/ Ty-Raps
Parts List
ITEM DESCRIPTION PART NUMBER | QTY
1 |Concept 3 Float 42-0018 1
Float Mounting Hardware Kit 12-0071 1
(BELOW)
2 _|M8x45 S/S Hex Bolt 22-0022 5
3 M8 Fender Washer 28-0008 5
4 _1M8 Flat Washer 28-0018 5
§ {M8 Nylon Lock Nut 26-0007 5
6 iNylon Tie (NOT SHOWN) GPS008 3
www.otterbine.com
1-800-AER8TER 75-0073 Rev 08 60Hz Concept 3 7
