Otterbine Barebo Inc.
f \ a -
i
j
yo
. , ft
392.91mm 2 an
[15% inl / |
eos e |
| fe | if
; H
Bape ta i Hi
342,77 mm———+ | iH
[13/4 inl 371.48mm | Hh
fe [145ginp
OVERALL DIMENSION MOUNTING HOLE LAYOUT
Cc. PCC Mounting
1. To prevent damage to the enclosure mount the enclosure using all four (4) mounting holes.
2. Whenever possible do not mount the PCC in direct sun light.
D. PCC Cables & Connections
1. Only Otterbine Barebo, Inc. factory approved power cord is to be used from the PCC to the aeration unit with no
junction boxes or splices. Only use power cord gauges and lengths specified by Otterbine at the time of cable purchase.
(Contact your Otterbine Distributor for proper cable sizing)
2. It is recommended that all exposed cable between the PCC and the shoreline be installed in non-metallic conduit. It is
important that aerator and lighting cables be installed in individual conduits to avoid induced interference between cables
which causes random GFCI tripping.
3. Always use strain relief cord connectors to attach the Otterbine cable to the PCC.
4. Cables and conduits must only enter into the bottom of the PCC.
5. Factory connections may loosen during shipping. Verify tightness of all screw terminal connections before energizing.
6. Power input and output wiring connections are accessed from the bottom of the enclosure. The terminal blocks for the
cable connections are located behind the hinged swing panel. Loosen the captive screw on the right center of the swing
panel for access.
Terminal Torque Values: Input — 45 in/lb. Maximum, Output — 30 in/lb. Maximum
ae a
= se AUX CONTACT,
aN ,
\
‘
SWING PANEL VIEW SUB-PANEL VIEW
www.otterbine.com
6 75-0073 Rev 08 60Hz Concept 3 1-800-AER8TER
