Nose Plows for 6 Wheel Truck
A. Astee!l 11‘ power angle trip edge plow with %” mold
board, no less than 40” high, punched to AASHO standards
12” on center with caster wheels shall be standard.
B. Plow shali be complete with a carbide cutting edge and
cover plate
C. Trip edges shail be punched to accept a 132” standard hi-
way punch cutting edge
D. The moldboard shall have 2 curb shoes (one each end of
cutting edge), each curb shoe shall not be less than 1-3/8”
thick.
E. 2 Caster wheels per plow shail be supplied.
| F. The drive frame and reversing mechanism shall consist of
an “A” frame, a truss frame, and 2 single acting 3-1/2”
hydraulic cylinders with a 16” stroke.
3" Diarneter
G. Maldboard and truss frame shall pivot about the “A”
frame on a removable lubricated pin not Jess than 3” in
diameter and up to 37 degrees to either side of chassis
centerline.
iH. The “A” frame shall be fitted with a3 point lift chain
arraignment, this shall accommodate plow reversing
operations.
{FB1005-092719 6 Wheel Dump Truck Up-Fits
Page {5
