3.08
ASBESTOS WASTE DISPOSAL PROCEDURES
This Subsection specifies requirements for the removal, handling, and disposal of all
asbestos-containing materials from the site except for non-friable asbestos-containing
transite pipe that shall be disposed of in accordance with Subsection 3.06. All costs
associated with complying with this Subsection and any other applicable Federal, State,
or local regulations regarding packaging and disposal of ACM shall be included in
payment items in this Subsection.
The Contractor shall package, label, and remove all asbestos waste from the Work Area
or Regulated Area as specified below. Packaging shall be accomplished in a manner
that minimizes waste volume, but insures waste containers shall not tear or break.
Transportation and disposal of the containerized waste at a landfill previously accepted
by the Engineer shall be the responsibility of the Contractor.
Waste Labeling:
1. Warning labels, having waterproof print and permanent adhesive in compliance
with OSHA, EPA and Department of Transportation requirements, shall be
affixed to or printed on the sides of all Disposal Bags or transfer containers.
Warning labels shall be conspicuous and legible.
2. In compliance with NESHAPS, 40 CFR, Part 61.150, all waste containers or
Disposal Bags shall be labeled in accordance with applicable regulations and
include the following:
° Name of waste generator, and
° Location of where waste was generated.
Wetting of Waste: A fine water spray shall be used to keep the top layers of waste in
containers thoroughly wet at all trmes. When a waste bag 1s full, air within the bags
shall be evacuated with a HEPA Filtered Vacuum and be securely sealed with tape or
other secure fastener.
Waste Container Decontamination and Removal Procedures: The following procedures
shall be followed whenever containers or equipment are removed from the Work Area
through the personnel Decontamination Facility.
1. The Clean Room shall be considered a holding area only during the period of
active waste transfer for the purpose of the loading of carts or drums. Storage of
waste and carts (or drums) in the Clean Room 1s prohibited.
2. Waste removal shall not occur during worker shift changes or when workers are
showering or changing. Care shall be taken to prevent short circuiting and
02111-41
