1.04
SUBMITTALS: IN ACCORDANCE WITH REQUIREMENTS OF
GENERAL SPECIFICATIONS, SUBMIT THE FOLLOWING:
Six sets of manufacturer's literature of the materials of this section shall be submitted to
the Engineer for review.
PART 2 - PRODUCTS
2.01
MATERIALS:
PVC non-pressure sewer pipe 4-inches through 15-inches diameter shall conform to
ASTM -_ D3 034, 18-inches through 27-inches diameter to ASTM F679, all with SDR of 3 5
unless noted, and shall meet the specific requirements and exceptions to the aforementioned
specifications which follow.
PVC non-pressure sewer pipe shall be furnished in standard lengths.
One pipe bell consisting of an integral wall section with a solid cross section rubber ring,
factory assembled, shall be furnished with each standard, random and short length of pipe.
Rubber rings shall be provided to the requirements of ASTM D3212.
The rubber ring shall be retained within the bell of the pipe by a precision formed groove
or recess designed to resist fish-mouthing or creeping during assembly of joints.
Spigot pipe ends shall be supplied with bevels from the manufacturer to ensure proper
insertion. Each spigot end shall have an "assembly stripe" imprinted thereon to which the
bell end of the mated pipe will extend upon proper jointing of the two pipes.
PVC fittings shall be provided with bell and/or spigot configurations with rubber gasketed
joints compatible with that of the pipe. Bend fittings with spigot ends shorter than the pipe
recess bells will not be allowed. The shorter spigot end would not allow proper seating of
the spigot in the mating bell and would permit undesired contact between the mating bell
and the outside of the fitting bell.
All pipe delivered to the job site shall be accompanied by independent testing laboratory
reports certifying that the pipe and fittings conform to the above-mentioned specifications.
In addition, the pipe shall be subject to thorough inspection and tests, the right being
reserved for the Engineer to apply such of the tests specified as he may from time to time
deem necessary.
H. All cutting of pipe shall be done with a machine suitable for cutting PVC pipe. Cut ends shall
be beveled when recommended by the pipe manufacturer.
02085-2
