Starting System:
e Check and record specific gravity reading of each battery cell
(if maintainable).
¢ Check for proper level of electrolyte in each cell.
© Check battery charger for proper operation and record amperage reading.
* Check and record the last date that batteries were replaced. Recommend that
batteries be replaced every three years, regardless of condition.
Control Panel:
© Verify gauges are operating and record readings.
* Check for presence of any warning lights/alarms.
¢ Perform lamp/bulb test.
Safety Controls - check for proper operation of safety devices:
* Overcrank
¢ Overspeed
¢ High Coolant Temperature
¢ Low Oil Pressure
¢ Not-in-Auto
e Emergency Stop
Fuel system:
e Inspect engine gas lines, regulator and carburetor for signs of leaks/corrosion.
e Inspect throttle and mixture valves and linkage {if equipped) for proper operation.
* Inspect ignition system (magneto/distributor/spark plugs/wires).
Operational Checks with Engine Running:
¢ Check for any leaks or unusual noises.
° Verify proper voltage and frequency via control panel gauges.
© Check for proper air inlet.
¢ Operate for no more than five (5) minutes without load.
Perform five (5) minute full generator output test. Customer representative must be
present to operate necessary circuit breaker to allow transfer to emergency source.
Walk-around inspection:
e Visual inspection of generator and environment.
¢ Check for signs of rodent/insect activity.
Conclusion of visit / Recommendations:
¢ Control panel: confirm control switch is in “auto” position.
¢ Circuit breaker: confirm genset is in run status
¢ Provide written recommendation(s) for any suggested repairs.
® Make electronic copy of inspection report available to customer.
¢ Provide written estimate of additional work to customer within one week of service
visit.
¢ Technician will clean up and dispose of any waste
