Workspace Products
MAINTENANCE PROCEDURES
LYON WORKSPACE STANDARD SHEET METAL LOCKERS
ANNUAL INSPECTION AND MAINTENANCE
* Clean interior and exterior of locker using a mild soap solution applied with a damp cloth
or sponge. Lockers must be thoroughly dried. Use of caustic cleaners/disinfectants will
damage the locker finish and void your warranty.
* Tighten loose hardware on body and hooks with 3/8” hex nut driver
* Tighten loose hardware on handle assembly with 14” hex nut driver
* Adjust door jambs on frame member if door does not latch properly with pliers or
SJTOOL2 (available from Lyon). Adjust downward if door hangs up and upward if door
fails to latch. Door jambs can be lubricated with a wax stick.
* Check to see that sliding catch is moving freely and the roller spins freely. If the parts do
not operate freely, contact your local Lyon representative.
* Lubricate hinges with a lightweight machine oil making sure to wipe off any excess oil.
¢ Waxing of lockers is not necessary, however if preferred, use a high-grade automotive
type wax.
* Touch up nicks and scratches as required. Featheredge deep nicks and remove any rust
with fine emery cloth. Contact your local Lyon representative for all spray on or brush
on touch up paint in specified colors.
* Replace any badly worn or broken parts of unit by contacting your local Lyon
representative.
Replacement parts can be purchased from: Lyon Workspace Products
P.O. Box 671
Aurora, Illinois 60507
Attn: Customer Service
800-433-8488
Note: Retain installation drawings and shipping bills of material for reference when
ordering replacernent parts.
Sheet # 6234-CA
PO Box 671, Aurora, IL 60507-0671 Lyonworkspace.com ph 630-892-8941 fx 630-892-8658
