OOD EXD e
fio-24 4 38"
MACHINE SCREW ANO
f-2e 2
MACHINE SCREW
HOODS aRE 10 BE CUT TO FIT LOCKER
wowT “@
4
ROWS, AND COMPLETELY ASSEMBLED WITH
0-24 x 3/8 TR, HO, ACHINE SCREWS
AND NUTS BEFORE PLAOQNG ON LOGHERS,
OPAL HOOD & END, AND
ATTACH wT OK 1/2" »
METAL SCREW
oxo CAP
CUT HOOD AS REQUIRED AT (1)
ENO OF EACH ROW. EITHER RIGHT aN
OR LEFT HAND END UAT BE CUT
—— KOOD £40
DETAIL AT
9 EXPOSED CUT END
Fee — TO ats a aa ms gent MULTIPLE HOODS
9 METAL SOREWS. OFMLL, ANC FIGURE 4
FASTEN HOOD ENDS ~~ ASSEMELY TO WALL NOTE:
oly al bail) Rens ALL HOODS ARE 60" LONG, THEY ARE
7 FIGURE 2 TO EXTEND OVER THE ENTIRE LENGTH OF
SECTION A~A THE ROWS, INCLUDING FRONT FILLERS,
PTEeaKaaria Gea none i HOOOS ARE NOT TO EXTEND INTO CORNERS.
AT CORNERS USE SLOPING TOP CORNER
FILLERS (END CAPS ARE NOT REQUIRED
WHERE CORNER FILLERS ARE LOCATED),
FIGURE 3 iL.
1. ATTACH/ANCHOR HOCD ENDS TO
THE LOCKER OR TO THE WALL
(SEE FIGURES 1. 3, 4. AND 8.)
2 ATTACH HOCD SUPPORTS TO HOODS ON
APPROXIMATE 30” CENTERS.
(SEE FIGURES 2, 8 AND 11.)
3. COMPLETELY ASSEMBLE AND CUT TO FIT
HOODS BEFORE ATTACHING TO LOCKERS.
(SEE FIGURES 2, 3 AND 4.)
1" %1 1/2" 16 GA SUPPORT ANCLE
FURNISHED IM 77" LENGTHS. ERECTOR 10
CUT SUPPORT ANGLES AS REQUNRED AND
FURMISH FITTINGS FOR ANCHORING TO WALLS. = 4. PLACE HOOO ASSEMBLY ON THE LOCKERS.
SE OCD SupRORTS (SEE FIGURES 5, 6, * 8, 9 AND ES
= TION ATTACH UNCUT END. (SEE FIGURE 2.
aase, Ser DRILL HOOD AND END. AND ATTACH THE
END CAP AT CUT END, (SEE FIGURE 4.)
USE A 5/16" SOCKET WITH SCREW GUN 70
ORIVE TEK SCREW THROUGH LOWER HOOD
FLANGE, OR DRILL A 9/64" DIAMETER
. PILOT HOLE AND USE SOCKET WRENCH OR
ae 6 SAF pene NUTDRIVER
SCREWS SCREWS
5. FIGURES 3, 6, AND 7, SHOW THREE
EXAMPLE SINGLE ROW LAYOUTS.
lV ASSEMBLY INSTRUCTIONS
SINGLE ROW SINGLE ROW FOR FIELO CUT
ROW
WITHOUT WALL ANGLE WITH WALL ANGLE SHOURE 10 pels alte
FIGURE 8 FIGURE 9
Ce See ee
Fo, Ore AURA, OT
Five
oma
INSTALLATION OF SLOPING HOODS tne 6221-CA
